I have one of the above with the sliding dropout.
Where can I get a gear cable and finishing kit with the correct ferules etc to fit the frame? At the moment its looking a bit untidy!
I cant see a kit for this on the On One website although I may be "looking like a man" as Mrs Surfer would say!
Cheers muchly!
erm...I have same frame. it is continuous cable run to rear. Any standard fittings are ok at the ends. I have a reel of shimano outer cable so length was not a problem. if you buy a "kit" then often they come with precut sections.
Thanks for that.
I have done the same but the ferrules (?) I have used to fit into the small braze ons under the top tube dont seem to fit properly. In my idiocy I had assumed there must be a specific size/type. If its standard I just need to look harder.
Cheers
No need to fit ferrules under the top tube, the gear cable outer just passes straight through them. They are a sloppy fit though.
as above, no ferrules on top tube. full, uncut outer cable passes through.
Thanks for that!
Surfer
This topic has been closed to new replies.
Advertisement
Advertisement
Advertisement
Advertisement
Advertisement
