Morning all
Have taken off the shock to put coil on and cannot remember which way the washers go!
3 washers on the front shock mount came off? (2 small and 1 larger) could someone check where the washers should be. I can't work it out as there is room in the mount for 1 washer? is that right?
cheers
Nick
anyone>
Can you post a picture of the washers and i'll have a look at mine and work out the order.
What coil have you got? I was planning on doing the same.
Should be the same as the washers in this Mega shock bolt pic from CRC...
Only shows two washers though 
Great thanks
Have Van R from my old remedy. Rode the Monarch yesterday and not very impressed. rebound is way to slow even fully dialled up and felt dead.
picture of bolt and 3 washers!
Nuke - yes thats the problem i saw that!!! you in tomorrow 
Not until the evening but no rush on the tools. Might need the cutters towards the end of the week though as I have accidently bought another frame 
Good to hear the Mega is finished...ish
I can only see the two washers on mine. One on each end. Not taken it all the way off, just loosened them. Can't see the third on mine. Sorry.
nothing on the inside of the mount?
Ive whipped it off and had a look. No nothing in the inside just the bushing butt directly to the mount.
OK, thanks
wierd as when i put mine in there is room for a washer! without it moves about
cheers though for your help.
freeridenick...any experiences with the van coil in your mega??
thanks !
accu - bloody brill....
took her to molini on october and 23,000m of descending over 5 days
chasing my mate on his Session DH bike 
going to get it pushed on the next service -
good to hear...
23.000 in 5 days.....
thanks...
You must log in to post.
Advertisement
Advertisement
Advertisement
Advertisement
Advertisement
