Viewing 8 posts - 1 through 8 (of 8 total)
  • Cutting down carbon bars
  • gj78
    Free Member

    Whats the best way to cut down some carbon bars?

    Stoner
    Free Member

    half from each end, not all off from one end.
    HTH

    gj78
    Free Member

    Thanks Einstein! 🙂

    scaredypants
    Full Member

    I’d take out a bit from the middle so the grips & levers can still fit properly

    1freezingpenguin
    Free Member

    A hacksaw with a blade made for cutting carbon or get you LBS to do it for you.

    bencooper
    Free Member

    Fine-bladed hacksaw or Dremel. Watch out for the dust, if you’re paranoid that way.

    phil.w
    Free Member

    Use a new blade with 32tpi. This is all your LBS will do.

    rewski
    Free Member

    As phil says, just do 10mm at a time and try out though.

Viewing 8 posts - 1 through 8 (of 8 total)

The topic ‘Cutting down carbon bars’ is closed to new replies.