Hello used search and found htII bearings to be 6805 in size but when i fitted some this morning the central hole is much to large, what is the correct size please?
thank you kindly
Bike Forum
[closed]
Ahem... hope bottom bracket bearing size not 6805!?
-
Posted 1 year ago #
-
Not sure if they're available from ordinary bearing suppliers, I think they're "licensed" bearings.
Posted 1 year ago # -
Do they not have a number stamped or printed on, or on the seals? Alternatively try simplybearings or similiar with the ID OD and thickness and see what you find.
Posted 1 year ago # -
Hope have their bearing contract with FAG/INA. Try Brammer for supply. Bearing numbers are on the outer race.
Posted 1 year ago # -
Or just measure the inside and outside diameter and the width or try http://www.mountainbikecomponents.co.uk/for all your bearing needs.
Posted 1 year ago # -
enduro bearings fit but arn't stainless I couldn't source any cheaper
than crc at £16 eachPosted 1 year ago # -
http://www.bearingboys.co.uk/G_Flange_Bearings_-_Metric-2219-c
Top hat replacements here I think ,just need to work out the right size
Posted 1 year ago # -
sorry have stupidly binned them already is anyone able to confirm measurements/bearing numbers please and thank you
Posted 1 year ago # -
They should be 24mm ID with the same OD as 6805.
Posted 1 year ago # -
yup 37mm x 24mm x 7mm.
fitters i spoke to said they were "manufacturor only" and couldnt order them
Posted 1 year ago # -
These bearings should do it then!!
Posted 1 year ago # -
http://www.ukbikestore.co.uk/wl.aspx?3&req=0-230_6011
And available in the uk
Posted 1 year ago #
Topic Closed
This topic has been closed to new replies.
