Forum menu
Topic starter
Is there a way of running tapered forks in a 1&1/8th headtube?
Posted : 09/01/2014 11:22 pm
No
Posted : 09/01/2014 11:23 pm
NO NO NO NO FFS
Posted : 09/01/2014 11:23 pm
[img] 
[/img]
Yeah. Just whack it in
Posted : 09/01/2014 11:25 pm
[img] 
[/img]
Posted : 09/01/2014 11:27 pm
[img] 
[/img]
There is always a way. But really which bit of mind bending physics were you thinking would make it happen?
[img] 
[/img]
Posted : 09/01/2014 11:36 pm
Topic starter
Ha ha ha!
Posted : 09/01/2014 11:43 pm
Yes. Just use a 36" back wheel to get the head angle back to normal.
I honestly don't know why nobody has thought of this before.
Posted : 09/01/2014 11:51 pm
Inch and half ones don't fit either
Posted : 10/01/2014 12:20 am
A 40mm peg does not fit in a 30mm hole.
Posted : 10/01/2014 2:28 am
davewalsh - Member
A 40mm peg does not fit in a 30mm hole.
round or square?
Posted : 10/01/2014 2:39 am
Depends on the hammer 😉
Posted : 10/01/2014 2:42 am