Bike Forum
4
Posts
4
Users
0
Reactions
55
Views
Topic starter
One week after putting them on the brake pad material came off my aztec XT sintered pads. Luckily I was only going down a slight slope and nothing happened. Is this common? Should I send them back so they can improve their manufacturing processes? Or is it just one of those things - £15 or so easy come easy go?
Posted : 05/06/2010 10:07 pm
I had the same with my Aztecs but that was years ago on some old m4s. Put it down to using the brakes too much on a dh run bit apparently their just not that good
Posted : 05/06/2010 10:54 pm
Happened to mine too!!!!
Posted : 06/06/2010 10:39 am
send em back! £15 isn't cheap..
Posted : 06/06/2010 10:44 am
Topic starter
Trouble is if I send them back and they replace them would I trust them again?
Posted : 06/06/2010 1:53 pm