Think i am being a numpty here!
I have an M770 xt front mech
[img] 
[/img]
Supposedly dual pull. I need a top pull (from top tube down) but cannot for the life of me get it to work. Is it just attached straight down or does it require looping round the cam?
HELP before madness sets in! Are they ALL DUAL PULL?
Just straight down here and it works fine
Pretty sure that's straight down between the past cable stop and the mech - no need for the cam
humour me with a pic please
Straight down but remember to use the spacer or if you dont have one, your fingers to get the correct cable tension for the 22T cog before you nip up onto the cable
racing_ralph - Member
humour me with a pic please
OK - how about this one?
[img] 
[/img]
genuine lol 🙂
Sorry - but I only run XTR.
Does this help though - I assume it's the same configuration
[img] 
[/img]
Still struggling - i cannot get the chain over to the biggest chainring. Same routing as per druidhs pic.
On the chainset - 68mm shell - 2 spacers on drive side?
sorted - i i was being a spaz 😳