[Closed] Pike airshft circlip

Push in the plastic bit behind circlip in, in order to stop it pressing against said circlip.

....you have let all the air out first, yes?

Yeah all airs out. So the plastic bit which stop the clip being pushed together do i push this down to allow the clip to be compressed?

Yea, I found this helps, just use your fingers, releases any preload against the clip, decent circlip pliers help too.

Ah thank you - After trying again i see what you have to do now, push it down pretty firm and then push it under the clip.

Thanks again

Good tip for this is to drop a suitably sized socket over the air shaft, push the socket against the air shaft guide (plastic bit) and remove circlip. Just easier than having fingers in there at the same time. You'll need to do the same for refitting.

I had exactly the same problem for a while yesterday, watching how to vids on your tube said just push to the plastic tab one side, that doesn't do anything you need to push it back into the shaft and under one end of the circlip. Once you know you can press the whole head end a few millimetres it's a doddle. A push and press under the circlip and push it again when refitting.

Did anyone happen to be dropping from 160mm?

I need a 160mm pike airshaft to raise the travel on my 150mm forks.

27.5 forks.