Forum menu
Topic starter
I suspect this is a stupid question to ask, but I was slightly taken aback when swapping out my pro II front hub bearings to find there is not a classic axle running through it. I assume this is correct?
The end caps seem to fit directly inside the inner bearing retainers and there is then a spacer sleeve between the two bearings(?)
I am pretty sure this is OK, but I was just a bit "errrrrm" when I took it apart!
It has gone back together fine(!)
Posted : 11/07/2014 8:57 am
That's right.
You can replace those end caps with 9mm bolt thru, 15QR and various other axle standards.
Posted : 11/07/2014 8:59 am
yep, seems to work, though I do seem to have lines forming on my maxle from the end edges of the caps.
Posted : 11/07/2014 9:49 am