Does anyone have a link to the dimensions of IS disc brake hubs? I have some Coyote hubs that were once built up into a wheel (nice hubs, cart bearing etc) but the disc mount face seems to be about 2mm displaced to my DDG hubs (measured from the frame dropout face). Was going to put them for sale but if they're non IS I cant really do that as it'd be unfair on the buyer, might hae to make them into trials wheels as my trials bike has no disc mounts.
No dimensions i'm afraid, but I seem to remember that hub face position being changed a while after the introduction of the standard, and also seem to remember it being in the region of 2mm as well.You should be able to face the mount, or space it out enough to cope with the difference.
I used these [url= http://cgi.ebay.co.uk/MTB-Syntace-Rotor-brake-shims_W0QQitemZ380095507650QQihZ025QQcategoryZ58082QQssPageNameZWDVWQQrdZ1QQcmdZViewItem ]HERE[/url]
Ahh thanks for that guys, I didnt realise the standard had changed (whats the point of a standard then!?) - I'll have a look at those disc spacers!
Ooh, or [url= http://www.chainreactioncycles.com/Models.aspx?ModelID=3288 ]These[/url]. Didnt even know these things existed, was actually just looking to buy a lathe to make one!
