Forum menu
Hello everyone, i wonder if you could help me? does anyone have the hope bearing pushes used to service them? If so is there any chance that you could.measure the inside and outside diameter for me please, as i have access to a lathe and hopefully (no pun intended) save myself some money.
cheers
Mark.
You might be easier getting the measurements from the bearings, would be easy to get the numbers from ebay then the dimentions from the manufacturers. Just build the tools with some reasonable tolerances and you'll be fine.
Seems like a lot of hassle as they are only £25 or so.
BB or hubs?
I've got the BB ones I can measure for you.
If your doing a Pro2 front with bodged tools, take care of the little lip as its easily damaged.
Pro 2 hubs is what i am trying to service, its no hassle as i am sure that my employer will be more than happy to supply me the material and time???
Pro 2 hubs is what i am trying to service, its no hassle as i am sure that my employer will be more than happy to supply me the material and time???
Dunno if they're the same, but my Bulb's and XC are always done with a hammer and various sockets pushed against the outer race..