UPDATE: CLASSIFIEDS section refreshed, redesigned, searchable: Go take a look
I got some sunline grips off CR. They seem very tight when going on. They scratched my Easton CNT bars so I didn't try and push too hard. Any tips? Cheers, Josh
Are they Lock Ons or not?
If no, try some hairspray. Acts as a lubricant, then dries to form a mild adhesive. Top tip.
Yes lock ons sorry shud of said
i use GT85 to get non-lock on grips on and off
They aren't the best lock on design - completely remove the grub screw. Bit of grease to stop them scratching?
Oh, and don't overtighten the end caps or they just wreck the plastic (I [i]almost[/i] did this)
is the grub screw/screws the one that tightens the lock on clamp? I'll give that a go...
I only use non-lock-on grips on carbon bars now.
Far too easy to scratch or overtighten them.
