Forum menu
Topic starter
Anyone know how to do this or a link to anywhere with instructions.
Plenty of stuff on how do the rear but not the front.
I have removed the non disc side cover easily enough but not the disc side is it just lever the cap off with screwdrivers and drift the bearings out?
Cheers
Posted : 05/06/2009 10:36 am
Use 2 scrwdrivers or needle-nose pliers to proze out. Then just hit either end of the axle with a mallet. Depending on how well they're seated will determine the scale of whack, and type of hammer (rubber mallett or club hammer).
Installation is similar in reverse. Sockets work as drifts.
Posted : 05/06/2009 10:44 am
Topic starter
Easy peasy and job done took less time than to type my thanks Pieface
Posted : 05/06/2009 10:56 am