UPDATE: CLASSIFIEDS section refreshed, redesigned, searchable: Go take a look
Searching the interwebz I found [url= http://singletrackworld.com/forum/topic/conversion-of-standard-qr-hope-xc-front-hub-to-qr15-why-wont-this-work ]this thread[/url]
did anyone get it to work?
Not economical. I got my Pro2 front hub for £20. Bearings/custon washers/spacers would cost more than that
LOL - I did actually make it work but only to prove that it could be done really. It'd be much easier to swap the hub for a 15mm one.
Would you not have to factor in the cost of new spokes and a wheel building jig?
Same spokes usually and you can built a wheel in a fork 🙂
Cheers Clubber, did you use the hope proII internal spacer?
No, I got one made up but I could get it done free. I wouldn't have bothered if it was going to cost.
