Topic starter
hi all i just tried to install a truvativ shift guide bb fitting. i got the cranks and bottom bracket off ok and put the guide on, then the botom bracket. i then installed the crank on drive side and it was all going ok but when i installed the left crank and tighten it up it goes to tight and stiff. my question is do i need a new bottom bracket and if so what size is it the bottom bracket width or the spindle width to increase? the old one is a shimano 52 size 68/110 and there were no spacers
many thanks
adam
Posted : 26/07/2011 8:56 am