Forum menu
[Closed] Cassette install on Hope Pro2 XD driver problem...
Topic starter
Hi chaps,
I'm installing a SRAM 11sp cassette onto a Hope pro2 evo XD driver hub.
The problem is, the cassette lockring tool doesn't engage deep enough to get a good amount of torque through the cassette. The tool fits deep enough on my DT Swiss XD driver hubs, but on the Hope hubs it seems to butt up against the 12mm axle spacer.
Has anyone got around this issue?
Cheers
Ricks
Posted : 02/04/2016 11:26 pm
Topic starter
Finally found the answer to my question...
Take the end cap off.
http://singletrackworld.com/forum/topic/sram-xx1x01x1-cassette-on-hope-xd-driver-issues
Posted : 02/04/2016 11:30 pm
Tale the axle adaptor out first 🙂
Posted : 02/04/2016 11:30 pm
Topic starter
That's one for the #fail album 😉
Seriously, I didn't even think of that. Been using DT wheels for too long now, and forgot all about removalable end caps.
Posted : 02/04/2016 11:41 pm