Topic starter
I'm looking to build up a hugo52 29+, the spoke holes are offset 5mm either side of centre, there isn't anything to take that into account in the dt Swiss calculator. Do I just subtract the offset from the distance from hub centre to flange?
LBS said to just ignore it but that doesn't seem right.
Posted : 28/01/2016 5:34 pm
Yes, just subtract from the centre-to-flange distance.
Posted : 28/01/2016 6:12 pm
It'll make next to no difference, maybe 0.5mm, probably less
Posted : 28/01/2016 6:16 pm
I found a calculator that would allow for offset drilling, hang on I'll have a look.
Posted : 28/01/2016 6:23 pm
here it is. Ignore code errors.
Built a set of Light Bicycle offset drilled fat bike rims and spoke lengths were good
[url= http://www.kstoerz.com/freespoke/fullcalc ]http://www.kstoerz.com/freespoke/fullcalc[/url]
Posted : 28/01/2016 6:25 pm
Topic starter
That's ace thanks.
Posted : 28/01/2016 7:07 pm