Topic starter
I suppose the real question is - how accurate are the Tacx devices when calibrated ?
And whilst I'm asking, does anyone else's flow drift loads ? If I calibrate, do half an hour, recal, it's at -4. Setup again, half an hour later it's at -4 again. I warm it up before cal too...
Posted : 02/01/2012 9:07 pm
My flow reads 10% lower than my powertap, but its consistent
Posted : 02/01/2012 9:13 pm
Topic starter
I infer then that your flow doesn't drift. Interesting.
I'm assuming that a powertap is accurate, so 10% isn't bad.
Posted : 02/01/2012 9:17 pm
Never had much drift on my flow.
Always found the PT and flow to give consistently different readings.
Posted : 02/01/2012 9:31 pm