Anyone tried these?
Would allow me to experiment with a fair few options, bit I don't know if it would be strong enough in the long term. Any input much appreciated!
I shall guinea pig it then 😀
No experience of it, but from a 3-D printed design point of view it looks like he's done a good job & not scrimped on material to save a fraction of a gram.
Re-assuring to see threaded inserts & what looks like a captive nut, rather than just threading the plastic.
I am not sure about the hinge - it looks like just a press-fit rod which should be OK. It's not like it's an active joint (only when you fit or remove).
I saw something similar on Amazon when looking for an adaptor to take my ipsec B 10sp Saint shifter to a bar mount.
Couldn't find one and I have a 3D printer for just such an occurrence
Guess I should get drawing !
I bought but never needed to use an ispec b version of that. Felt quite flimsy but I’m sure would do the job.