Forum menu
I've tried the threaded rod and washers thing and although it works it's still a faff. The cyclus press looks good but to fit a tapered headset you need to buy two of the buggers. Should I buy two or can I buy one and get the drifts elsewhere?
Hope make a 1.5" press that'll probably work with the Cyclus tool.
A Unior one would do it - not cheap but built like a tank
[url= https://www.bike-discount.de/en/buy/cyclus-plunger-1-1-2-for-press-in-tool-451157 ]Bike Discount De[/url] have the 1.5" adapters for the cyclus press listed
got a x tools one off crc cost about £35 , used it for the last 18mnths between 6 different bikes no problems at all , the actual press cups are stepped so fit a variety of headsets
Spookily I've just ordered a set from [url= https://www.bike-discount.de/en/buy/cyclus-plunger-1-1-2-for-press-in-tool-451157/wg_id-1344 ]Bike Discount[/url] in Germany as I couldn't source any in the UK. Since there's a £5 postage charge to the UK I ordered a set for [url= https://www.bike-discount.de/en/buy/cyclus-pressing-piston-semi-ihs-for-press-ttool-456363/wg_id-1344 ]semi-integrated headsets[/url] too to complete the set.
The order only went in yesterday, so obviously they haven't arrived and I can't comment on quality of service, but I had an email yesterday evening advising that the package was with the courier.
Thanks, men. I'll get one on order.