Forum menu
Help me out please people.
I've built a fitted workbench in the garage and want to put doors on the front and use it as storage.
[img] 
[/img]
The doors (2 pairs) are going to be in the same 18mm MDF as the worktops, and each will be roughly 3' by 2'. I want them to sit "on top of" the frame, rather than "in" it, if you see what I mean.
Are a pair of [url= http://www.ebay.co.uk/itm/5-PAIRS-OF-BRASS-FINIAL-HINGES-50mm-2-Fancy-Cranked-Flush-Kitchen-Door-Fixing-/201562218207?hash=item2eee0b5edf:g:qmAAAOSw~oFXDgZZ ]2in cranked flush hinges[/url] on each door going to be strong enough?
Thank you, people.
Yep
That's all I needed to know!
Thank you, internet person 🙂
HTH 😆
Just use some decent length screws when you put them on
decent length screws
Can't be more than 15mm on the doors - they're only 18mm thick.
Does the bit with the 2 slotted holes screw to the end of the door (I.e the 18mm wide bit ?)
( never used the m myself but that was what I was assuming)
Don't forget to pilot drill screw holes in MDF or it may split