Topic starter
i have a 9 spd M970 xtr rear mech paired up to some 10spd DA shifters. Can i use a later 10sp xtr rear mech with clutch with these shifters?
Posted : 07/05/2017 8:47 pm
Different pull ratio on 10 speed.
Posted : 07/05/2017 9:09 pm
+1 No.
Posted : 07/05/2017 9:24 pm
If you use a JTek Shiftmate #6 it will work.
Posted : 07/05/2017 9:27 pm
Topic starter
ta
Posted : 08/05/2017 9:20 am
There's also a way of doing it by drilling a hole in the actuation arm to route the cable through (changing leverage), but I can't find the place on the internet where I read it again.
Posted : 08/05/2017 10:17 am
