Forum menu
Has anyone got one I could borrow or even buy? Got to remove a left hand M970 crank and the tool is deffo required. Cheers 🙂
where are you? i've got one in devon you could borrow.
I have one near preston you can borrow?
Bolt
Cheers guys very much appreciated!! I'm down in Sussex, should've said, sorry!
Might have a lead on one to buy...
One here in Yorkshire. Can post if you promise to post back 😀
Do you 'really' need it? I've tapped mine off with a rubber hammer and they are fine if you are careful
slug - Of course I would but will see if my lead on buying one comes good
Rob - tapping it off will put a bit of force on the soft splines as it's not pulling evenly, so it may work but not ideal.
Used the tool on Rob Collivers M970 XTR cranks. They were so tight, that the tool broke, using a big lever in the hole.
Ended up with a Dremel and cutting them off. Fortunately they were destined for the bin.