Forum menu
Just about to install but no spacers i.e. 2 drive side 1 on the non drive.
They are the double set up but just using a single ring not sure if I should be using the spacers
Rich
If you've got a massive shell you won't need them, they're a normal width axle AFAIK
frame is a whyte 130 2014, just taken off the original GXP sram cranks
Youll need spacers if its a screw thread one I believe, I don't recall Whyte doing a 75.5mm BB shell.
just found the bloody things inside the plastic tool!!!!
What spacers should be on for a 1x11 XT bb and cranks?
I've got one thick one on the drive side. Is that right?
If you have a 73mm wide BB shell then yes, 68 runs 2 drive, 1 non drive.
Ok great. I do think I'm going to switch to the non drive side to see if it helps the chain line.
no spacers needed in the end struggled to get the preload cap on!!!
Have you measured the BB shell? Is it a threaded one?
Threaded just been for a ride setup is perfect!