Forum menu
Topic starter
Trying to insert a seatpost into my frame, it goes in fine for the first 5-10cm but then gets [i]mucho tighto[/i] and can't be pushed in any further. When I remove the seatpost it's coated with a thin layer of black sticky grease, guessing this might be the culprit? Do I need to clean the seattube out somehow, if so, what with?
cheers 🙂
Posted : 26/02/2010 7:40 pm
some degreaser on a rag on a stick? 😕
Posted : 26/02/2010 7:46 pm
is it bent?
edge of a steel ruler along the rear and hold up to light to see.
Posted : 26/02/2010 7:51 pm
I'm with GW, seatpost is probably bent.
Posted : 26/02/2010 8:04 pm
Topic starter
better bloody not be... it's titanium, so it'd be tough to do?
Posted : 26/02/2010 8:11 pm
Is this a euphemism?
Posted : 26/02/2010 8:13 pm
Topic starter
Is this a euphemism?
😆 seriously laughing myself silly re-reading what I typed in light of this comment 😆
If it [i]is [/i]a euphemism, how'd you recommend I sort my issue?
Posted : 26/02/2010 8:17 pm