Forum menu
Topic starter
Hi,
I have recently converted to tubeless and all is going well. However i have noticed some wet looking patches on the outside of the tyre and then found that it was the sealant because i have 3 thorns in the tyre. The tyre hasnt gone down at all so should i leave the thorns in place? Would it be a good idea to top up the sealant inside the tyre?
Thanks
Posted : 03/04/2009 11:55 am
pullem out and spin the thorn hole to the bottom , it will seal .
Posted : 03/04/2009 11:57 am
I pulled out a thorn to show off the super healing qualities of the tubeless set up. Of course the tyre went down. Too low on sealant.
My Contis seeped sealant through the side walls for a while then stopped.
Posted : 03/04/2009 12:09 pm