Forum menu
I have a set of these http://www.pinkbike.com/news/odi-troy-lee-grips-review-2011.html
They come disassembled, no biggie.
But it's impossible to get the collars onto the grips, they're basically a tiny bit too small/tight and the flanges can't get into them.
I've done by persuasion with a rubber mallet, but that can't be the right way. They're just grips FFS.
What am I doing wrong?
I always position the collar onto the end of the grip so that its lined up exactly and push it on a little bit so that it stays there. Then holding the grip with the collar underneath, press it down onto a solid surface until the collar pops on. They do go, there's a knack, once you've done a couple it becomes a lot easier
Yeah, same as above, on a flat surface, and push down hard, they click into place. Great grips.
OK, it's not impossible then. Thx chaps.
Have you loosened the screws on the collar a bit?
Screws aren't in the collars yet.
Well put them in then make sure they are loose 😉
Excellent grips BTW
screwdriver in the slot for my vans grips.
Get your girlfriend/wife to do it for you. 8)