[Closed] The sneaky cheeky tips and tricks page...

INVITED by vegetarians for dinner? As you’d no doubt be made aware of their special dietary requirements, tell them about yours – ask for a nice steak

Old but classic;
[img] [/img]

rossi46 (or anyone) do you have any more info on that bearings bodge?

cheers

ransos - Member

A piece of cardboard or a large puncture patch will bodge a slit in your tyre well enough to stop the inner tube poking through.

If you use mavic UST rims check the valve locknut once in a while - they are prone to corroding on as you go so long between punctures. Siezed valve out in the hills could be a nightmare if you did flat - you'd need a pair of pliers to get it out and stick a tube in there.

[i]A fiver or tenner is also good for this in a pinch - the paper is pretty tough.[/i]

Would make a change from throwing money at my bike to actually installing money on it, I suppose.

If you've got chain grease splatter on your skin or if your child Like mine manages to get chain prints all over his calves when riding in shorts.

To save scrubbing the skin away just gently rub over some marge (any brand even butter if you are posh) until the area is covered.
Then wipe off with a damp cloth (wets wipes work best) and it just disappears.

To save scrubbing the skin away just gently rub over some marge (any brand even butter if you are posh) until the area is covered.
Then wipe off with a damp cloth (wets wipes work best) and it just disappears.

2 things here.

1)my dirty mind is going into meltdown.

and

2)WTF do they put in margarine!

To avoid scratching your saddle and grips/shifters keep your bike the right way up when doing trailside repairs.

Having problems with tubes? Try tubeless.

bung a couple of latex gloves in your camelbak. That way, if you need to commit a serious crime whilst out on the trails, you leave no fingerprints!

Irritating Piles can be repositioned with a Crank Brothers pump and a healthy application of KY. Your Sportive will be a much more pleasant "race" after this.

A piece of cardboard or a large puncture patch will bodge a slit in your tyre well enough to stop the inner tube poking through.

Cut the ends of an old toothpaste tube and slit open. Saves on buying a tyre boot and you'll get at least one extra teeth clean out of it!

1) [Well known] Never get involved in a land war in Asia

2) Only slightly less well-known is this: "Never go against a Sicilian when death is on the line"!

Carry a small jar of honey with you on a trail, and if you tear your tyre beyond repair, simply smear a small (thin, or else the honey will just run) amount onto the crack and then leave in the sun to dry and harden, you may need to repeat the process again to get a second layer but I have done this a few times. It also works with inner tubes if you have run out of patches.

I don't run tubeless but I guess you could fix that too if you tear a tyre but probably need 4 layers min I'd say.

Edit, with inner tubes it's really only a get me home measure but comfortably holds 35 psi

😯 No not really it cannot be

Carry a small jar of honey with you on a trail

I have done this a few times

seriously? drink check, some cash check, spare tube check, phone check, small jar of honey, errrrr.
can't help thinking of tubby old pooh bear 'hummm time for something sweet'

Golden syrup works as well.

cardo - Member

For directional tyres and to avoid putting them on the wrong way round, most rotors have a rotation arrow on them , well I know Hopes do anyway.. works for me.

Surely the rotors being there at all, or even the rotor bolts if rotors aren't installed, is enough to mean it's pretty obvious which way the wheel goes round... 😕

Carry a small jar of honey with you on a trail,

If a bear attacks ,throw it over your riding partner and make good your escape 🙂

To save scrubbing the skin away just gently rub over some marge (any brand even butter if you are posh) until the area is covered.

Or just use shower gel.. 😯

Carry a small jar of honey with you on a trail
Golden syrup works as well

Rogan Josh you are Jim Lovell and I claim my £5. 🙂

[img] [/img]
Nearing Takeoff

For when the weather eventually gets back to normal again. Those fish shaped soy sauce bottles you get in supermarket sushi are ideal for holding a bit of chain lube.

Just got my Squirt Lube Trial - will be keeping the bottle!

No one expects the Spanish inquisition,

TIP:

Expect the Spanish inquisition.

[i]Siezed valve out in the hills could be a nightmare if you did flat - you'd need a pair of pliers to get it out and stick a tube in there[/i]

Carry a small pair of pliers (or leatherman type tool)!

Carry a small jar of honey

I have never put grass in my tyres, officer.

I'm calling BS, I'd rate this with putting grass in tyres

It's a Honey Trap

I'm calling BS, I'd rate this with putting grass in tyres

It's a Honey Trap

Yeah I'd Bee careful with this one.

After washing yer bike hotel shower caps are great for shielding rotors and calipers from spray lube like GT85.

Note: DO NOT use the O/H's pink Hello Kitty cap for this purpose. 😯

Made a mate do the grass-stuffing thing on Deadwater fell once. We didn't hang around to find out how delighted this made the midgies, but it's fair to say my mate didn't look too happy when he got back to the car.

I'm calling BS, I'd rate this with putting grass in tyres

I've done the grass trick. The rim sidewall had sheared so impossible to repair with a new tube. It's very slightly better than nothing.

No one expects the Spanish inquisition,

The irony being of course that the inquisition always sent advance notice so you always knew exactly when to expect them.

Rogan Josh - Member

Carry a small jar of honey with you on a trail, and if you tear your tyre beyond repair, simply smear a small (thin, or else the honey will just run) amount onto the crack and then leave in the sun to dry and harden, you may need to repeat the process again to get a second layer but I have done this a few times. It also works with inner tubes if you have run out of patches.

I don't run tubeless but I guess you could fix that too if you tear a tyre but probably need 4 layers min I'd say.

Edit, with inner tubes it's really only a get me home measure but comfortably holds 35 psi

This trick works so well, Kenda have named a new line of tyres in its honour:

[img] [/img]

Grass in tyre. Yup, saved me from a 12 mile walk home when my pump failed.

[img][URL= http://i81.photobucket.com/albums/j226/stevecurtis100/sellingstuff5010.jp g" target="_blank">http://i81.photobucket.com/albums/j226/stevecurtis100/sellingstuff5010.jp g"/> [/IMG][/URL][/img]

Ugly birds: become more attractive by simply moving North.
😈

To affix grips to bars, use a length of 2" double sided tape wrapped around the bar, cover in white spirit then slide the grip on.
Use increasing layers of tape to increase grip diameter, or use a longer length of tape and stretch the grip over it to reduce the diameter.

I've used the grass trick before.
Stuffed it with grass, pumped it up as hard as I could and raced to the nearest petrol station compressor to pump it up some more.
It was better than nothing, although I did get covered in grass juice.

I stuffed heather into a tyre once when I realised I had left the spare tube in a different bag.

It was quicker than walking, but only just. The stuff would frequently pack down and shuffle round leaving a gap, so I had to keep stopping to stuff more in the space. Eventually it was pretty much rock solid and heavier than the earth, but it worked, ish...

If you have greasy oily hands from working on the bike, simply squirt them with WD40 or GT85, wipe with a clean rag & hey presto... clean hands.

Stefmcdef deserves an *applause* for that one 🙂

Orange cordial will stain hydration pack bladders - lemon cordial will not.

Most hydration pack bladders are freezer safe despite the manufacturer recommending you to leave it somewhere warm to go mouldy.

Instead of buying the proper tool for removing valve cores, use a section of 10 speed chain as a wrench for removing the core, the gap between the side plates on the chain fit perfectly over the valve core flats.

[URL= http://i1098.photobucket.com/albums/g362/graeme_t/46D15399-5F0D-41BB-9753-04BA26911C33-6296-00000795002E628F_zps0d95be8b.jp g" target="_blank">http://i1098.photobucket.com/albums/g362/graeme_t/46D15399-5F0D-41BB-9753-04BA26911C33-6296-00000795002E628F_zps0d95be8b.jp g"/> [/IMG][/URL]

Tip 1.

If you taco your wheel beyond repair so badly that you even after straightening you can't get it to run through your forks without rubbing on the legs, take the tyre off and roll it home on the rim, to avoid carrying it.

Tip 2.

When doing the above, don't give in to the voice that says 'go, on I'm sure riding on a busted rim will be fine as long as you don't go mad' It won't be and you'll end up carrying the ****ing thing anyway.

Been doing some maintenance on your bike, got oily hands but run out of swarfega ? Just use fairy liquid with sugar added in. Job done.

Want to avoid the silly short service intervals on your suspension fork? Simple, if you have a lock out, always ride with the fork locked out.

When riding home rather inebriated from a friends stag do, on a fixie with knobbly flat pedals fitted because you're wearing smartish flat shoes..don't get distracted by the pretty moon, as it will end in a rather unpleasant episode of your feet becoming desynchronised from the pedal, which is likely to end in significant pain.

That is all.....

DrP