SRAM Road AXS poor shifting…

oceanskipper · 2025-01-12T21:19:40Z

I’ve got a brand new road AXS system installed and I cannot adjust out poor shifting from 11-10-9 which are 1 tooth increments. It’s worst going 11-10 and it’s not every shift but 6 out of 10. Basically it stays in the higher gear too long clicking as it does not catch the shift ramp fully and then does eventually go in. Once it gets past 9 it shifts instantly and perfectly all the way up the cassette and it’s also fine all the way down. Things I’ve tried… Hanger alignment checked with alignment gauge. Full installation setup from scratch following the SRAM procedure and b gap alignment using the SRAM tool. High/Low limit adjustment etc all perfect. Chain length correct. Brand new chain so zero wear. Removed and reseated the cassette. I’ve tried adjusting it out using the micro adjust also and while this improved it a bit it gets to the point that it’s rasping when I go too far and with no further improvement in shifting . Anyone else had a similar issue or got any bright ideas ? Faulty derailleur? Faulty cassette?

Page 2 / 2 Prev

Ioneonic

Posts: 455

Free Member

Great result - thanks for updating.

Posted : 27/01/2025 2:04 pm

Page 2 / 2 Prev