Topic starter
@oldnick should I remove all of the old threadlock before applying or just apply over what's left? it's fiddly to get it out so would rather just apply over the top if that's possible?
Posted : 09/06/2022 3:28 pm
Given it's a bike not some NASA probe costing bajillions I'd use a fine wire brush to clean loose gunk out of the bolt threads, then if it threads in smoothly you are good to go 🙂
Posted : 09/06/2022 3:30 pm
Topic starter
for anybody coming to this in the future, if you are considering retapping this article is a great introduction to the concept: https://knowhow.napaonline.com/know-how-notes-how-to-repair-damaged-threads/
this video was also very helpful:
Posted : 09/06/2022 3:44 pm
Page 2 / 2
Prev
