Forum menu
[img] 
[/img]
the two little rubber seals here..does anyone know if i can buy these separately or if i have to fork out for the whole mount kit...?
mine seem to have disintegrated into thin air on both ends!!
Can't you just use an o ring?
measure the diameter of the part labelled 'axle/pin' then go to a hardware shop or plumbers supplies and ask for a couple of O-rings that diameter, should only cost pennies!
erm yes but the o ring will be a lot more flexy whereas the seals here are fairly hard so the forces on the end of the shock would squish the o ring and soon render them useless..? or allow the shock/spacers to move and lead to premature wear..?
my shock is slightly pissed in the mounts so it hammers the seals double quick hence the need for hard wearing ones..