Forum menu
shimano disc brake ...
 

[Closed] shimano disc brake issue

Posts: 3366
Full Member
Topic starter
 
[#6825750]

Have a set of 615 deore brakes, had them for about 6 months no problems.
The rear I've noticed has very little Lever travel And the pads rub the disc.
Retracted the pads, but it returns to this after a few lever pumps.

Pads seem Ok too
Ill bleed it and see if this helps, but it did seem a bit sudden. Any ideas?

Ta


 
Posted : 31/01/2015 9:30 pm
Posts: 2082
Free Member
 

Is the caliper centred?


 
Posted : 31/01/2015 9:34 pm
Posts: 2082
Free Member
 

Actually ignore that. sounds like something else..


 
Posted : 31/01/2015 9:35 pm
Posts: 3366
Full Member
Topic starter
 

Yeah, I've adjusted and readjusted, set them with and without birzman spacers too.

Same thing.


 
Posted : 31/01/2015 9:35 pm
Posts: 4389
Full Member
 

Sounds like a sticky piston in the caliper. I had this on some Hayes Stroker Trails. Try removing the caliper from the frame and take the pads out. Clean round the pistons with a little oil. Pull the lever untill they move then carefully push them back. Repeat a few times.


 
Posted : 31/01/2015 9:53 pm
Posts: 3366
Full Member
Topic starter
 

Pistons are moving ok as far as I can see. Swapped pads with the front and the front is playing up similar to the back. So Pads I think.

Only look half worn to me!


 
Posted : 31/01/2015 10:32 pm
Posts: 3366
Full Member
Topic starter
 

Think I've figured this out.

oddly it's to do with the springs. I noticed that the pistons weren't retracting very well, so opened the spring up a bit. kinda solved the initial problem but also caused the pistons after about a minute to retract further, requiring the brake to be pumped a bit to find the bite point.

changed the pads now so all is back to normal, but thought I'd report back.


 
Posted : 17/02/2015 12:49 pm