Forum search & shortcuts

Seized forks...
 

[Closed] Seized forks...

Posts: 7
Free Member
Topic starter
 
[#378291]

Revelations.

OK - they were "due a bit of a service" having had no maintenance for the last 3 years. My regime was just clean & lube after each ride and they had developed a bit of stanchion wear and some play (worn bushings, I'm guessing)

however, after sunday's ride they have seized completely, as in no movement whatsoever. I really fancy the new maxle-lite Revs but I'm loath to shell out >=£500 at the moment.

What's the prognosis from the STW knowledge-base?

Sensible advice would be welcome as well as the usual abuse ;o)

Cheers,

SC


 
Posted : 10/03/2009 8:01 pm
Posts: 1427
Free Member
 

Take them to bits, clean and reassemble, you may get a bit more life out of them.

Can't make it any worse.


 
Posted : 10/03/2009 8:05 pm
Posts: 41952
Free Member
 

strip and re-asseble with fresh lubes and oil, wont cost more than a tenner in oils.

most likely the lowers have run out of oil completely, or could be more serious (bent damping rods, blown seals)


 
Posted : 10/03/2009 8:11 pm
Posts: 0
Free Member
 

You should have serviced them!!!

A service will probably get them going again, but you really need new forks, or crown stanchion assembly and bushings if this is is more economical (though unlikely I think). Then look after the things!! Lecture over 🙂


 
Posted : 10/03/2009 8:14 pm
Posts: 0
Free Member
 

Strip 'em down, check all the hardware for wear/damage, replace seals, new oil ten Hail Mary's for the unconscionable treatment of your bike and go and do four gnarly/rad things. Dude.

Amen.


 
Posted : 10/03/2009 9:40 pm
Posts: 7
Free Member
Topic starter
 

Cheers. Dude.

It's been a long time since I said ten Hail Mary's, but I feel it's a fair penance for my neglect.

How difficult a job is it? Any special tools needed?

(Stripping the forks, that is. Ten Hail Marys' I know how to do)


 
Posted : 10/03/2009 10:05 pm
 ton
Posts: 24309
Full Member
 

we have had a scottish related thread tonight about certain things.
dont let me bring up another merit of our friends in the north.....
spend some moola 😉


 
Posted : 10/03/2009 10:08 pm
Posts: 7
Free Member
Topic starter
 

Ton,

I'm hoping I can either do it myself with a skean dhu and a lump hammer or I can get someone else to do it for a barrowful of neeps.


 
Posted : 10/03/2009 10:14 pm
 ton
Posts: 24309
Full Member
 

😉


 
Posted : 10/03/2009 10:15 pm