Forum menu
Hi
I am thinking about buying a 2009 Turner Flux off CRC but I understand they are post mount on the rear.
The brakes I have are original Hope Minis (non mono) with a 180mm rotor and an IS mount.
I dont seem to be able to find an adaptor to make these fit-but I may just be being stupid!!!!!!
What options do I have to make these fit?
Does an adaptor exist?
Different half caliper?-if so where from?
New brakes? Would rather not do this at the minute due to the extra cost!!
Cheers
Steve
Hope adaptor HBSM20 will convert post mount frame to IS, but will also require a +20mm rotor(total cost about £35), other options are a new caliper half(seem to remember them being about £35, if still available new)in either a 9-74 post mount(will need a +20mm adaptor, or a 165mm rotor), or a no.5 type and HBSM20 mount to keep your original rotor.Parts, if still available, can be ordered from any Hope dealer, or you could put a shout on the classifieds.