[Closed] Orbea boost hub.

So, need to pick the brains of the STW collective.

Got a wheel with an Orbea boost 148*12 rear hub, the freehub bearings are dead so need to replace them or the whole body if it's a sealed unit.

But I can't for the life of me get the freehub off.

Not sure if it's an internal hex key job like on a Shimano one, but can't try that as I can't get the axle out in either direction. Feels like there is a flange on the axle in the middle, so maybe I need to use it to knock the non drive bearing out as you would on a Hope hub?

Anyone have any experience of this hub who can advise?

Cheers m'dears