UPDATE: CLASSIFIEDS section refreshed, redesigned, searchable: Go take a look
got a porflex 768 and in the process of getting a raceface group-set put on it...got stem handle bars and seat post evolve
want to put a raceface chainset on.
what measurements will i need to take to make sure its the right fit??teeth etc?
cheeers
bit new to all this
You need the width of the bottom bracket shell (it will be 68mm or 73mm)
The new style hollowtech 2 cranks accomodate both so it doesnt matter either way really.
Also, shimano cranks seem to be a better option than raceface i think
Also, the teeth are usually 22/32/44 on a triple ring setup, which will fit fine
FSA CK-1150TTT 44 32 22T
thats what its got on it at the moment
Whats wrong with the current one?
Just measure your bb shell width then. And buy whatever crank you fancy
