UPDATE: CLASSIFIEDS section refreshed, redesigned, searchable: Go take a look
Hi,
I have rebuilt an old mtb frame for commuting with a Kona P2 fork.
Thing is; there is huge space gap from the crown area where the holes for reflectors to the top of the tire for a xc fork?
I would like to fit a mudguard-anyone had any success or ideas or a mudguard that is height adjustable?
Thanks!
this is because it is suspension corrected. No idea if such a product exists, if it does I doubt it would look any better than a bodge with a steel bracket.
I bodged my surly 1x1 fork (a little bit suspension corrected) and it looks fine: far better with the guard nice and close to the wheel.
Cheers for the advice!
Seems that my clip on guards are too high for spray protection on the front!
Might try an L bracket from a diy store!
