Topic starter
Hi all
After finally getting settled in to our new house, I'm now finally clear of DIY and ready to start back on some bike projects :-))
Kinesis AT build is first on the list, I've got a rolling chassis built up and plan to run Sram Rival 1x11.
The internal cable routing is a new one on me so I was wondering how have people approached the rear mech cable routing.
Should I run a full cable outer to the bottom of the downtube or cut the outer to size at the adaptor port and ran the raw cable down?
Any help greatly appreciated!
Posted : 09/08/2018 12:11 am
I ran the raw cable down from the adapter port in the downtube. Looks and works fine on my double ring setup.
Posted : 09/08/2018 7:47 am
