Forum menu
So I have a Pro 2 Evo hub and I'm going to install an XD driver kit. The kit comes (as standard?) with 10mm bolt through end caps.
Am I able to simply pull these off and install standard Hope 9mm QR end caps?
Or does the XD 'driver body' require and XD specific 9mm end cap?
there's a specific XD end cap for 9mm or 142x12mm...
[img] 
[/img]
when i ordered my XXD driver, i was asked which kit i wanted...
looks like this .... http://www.chainreactioncycles.com/hope-pro-2-evo-freehub-body-sram-xx1-xd-qr/rp-prod106608
I've found this: http://www.jejamescycles.co.uk/hope-pro-2-evo-xx1-xd-qr-drive-side-spacer-135mm-id83626.html
I'm assuming the EVO axle is fine and I'll just need one of these drive side end caps and a standard 9mm non drive side end cap. Can anyone confirm?
You need one of what you've pictured, the existing non drive 135mm cap is ok to reuse, axle needs no modification.
Cool. Had hoped so