Forum menu
Topic starter
Hi,
My brakes are in need of new pads and as they feel a little spongy I'm going to bleed them as well. Do I need to set the reach and bite point adjusters before bleeding or dosen't it matter?
TIA Jackson.
Posted : 04/09/2013 10:34 am
Set them to maximum out for the best bleed (I was told this by Hope yesterday).
Posted : 04/09/2013 10:35 am
Adjust them all the way out so that the pad and lever are as far away from the rotor/bar as possible...bleed and then reset.
Posted : 05/09/2013 7:39 pm