Forum menu
Topic starter
The 3mm Allen bolt (the middle one)that holds the pads in place on my MPH caliper has disappeared.
[img] 
[/img]
I know the original MPH was based on the C2, but the design changed for later MPH calipers, like the one I've got.
Finding a replacement bolt is proving difficult, so would I be able to use a C2 split pin instead?
Even assuming it fits as a bodge, would I be in danger of my pads flying out halfway down a hill?
Posted : 25/04/2010 1:42 pm
I'd happily use a split pin.
Posted : 25/04/2010 4:29 pm
C2 pads have two holes, held in by two split pins.
MPH pads have one hole.
Can use MPH pad in C2 caliper, but not the other way round.
Anyway, I have a pin in my MPH caliper (which works with a C2-Pro lever) and it's fine.
Posted : 25/04/2010 5:43 pm