Topic starter
how does the rear cable get routed on the rear mech?
on the clamp plate thingie there is a lug that fits into a notch in the rear mech but the cable would have to do a 90 degree bend to get under this
or do I keep the cable straight and not put it through this lug?
Posted : 29/01/2011 2:02 pm
The lug is there to stop the plate turning when you tighten the bolt, just run the cable under the tab that sticks out(sometimes there's a groove cut into the mech for it too).
Posted : 29/01/2011 10:55 pm
