Forum menu
Topic starter
Need to replace the gear cable on my Cube AMS this weekend. Its internally routed and I'm rather tempted to drill the existing hole and run a full length outer through the frame.
Any reason not too or any pointers?
Cheers
Posted : 03/06/2016 10:07 am
Warranty would be my only concern.
Posted : 03/06/2016 11:36 am
Drill will snatch on the thin walled tube and make a mess. You can get special drill bits for thin walled drilling though if you still fancy it.
Posted : 03/06/2016 12:23 pm
If there is already a hole, needle file to make it biggerer
Posted : 03/06/2016 12:25 pm