Forum menu
..after reading the long thread re: Hope vs Shim cup & cone I thought I should check/service mine XT circa '05....
....front cones were loose 😯 could they have turned into the wheel thus crushing the entire race (bearing, as opposed to human...)??
Anyway, after purchasing a 2nd set of cone spanners(Pants LBS advice) the job was very easy to conduct. Packed in loads of grease and now they slip round like a wet dream with zero axle wobble 🙂
So my point is, erm...don't delay! Check your cones today!
PS: Bit of a crap post, but just in case you're dithering 😉
well... I have been dithering.. and I shall endevour to dither no more..
prob need to do mine too lol
I missed a hope v shimano thread?
Mine were done a while ago, they were way overdue though. Loads of metal filings when I cleaned it all out. Also one of the cones is a bit pitted. As such it spins a bit rough now, I just can't be bothered to get the new parts and sort it out tbh :\
I still don't have properly fitting cone wrenches so they come loose every so often. I hate cup & cone hubs, rather have fit and forget with cartridge bearings!
/Damn - disappointed now 🙁
Thought this thread was about a new type of razor.............