Forum menu
I've got an old monocoque frame (late '90s) in raw aluminium with a crack at one of the pivots and a cosmetic dent.. Well, I hope it's cosmetic.
And it could do with a new disc tab as a previous user cut off the old Pro-Stop mount. 🙁
Are there recommendations for a welder or frame builder in the Manchester/Liverpool area?
San Andreas???
Can't fault this guy:
[url= http://www.vernonbarkercycles.co.uk/ ]http://www.vernonbarkercycles.co.uk/[/url]
Based near Sheffield. He welded up the crack on my Commencal and did a superb job - very tidy and the joint is, doubtless, far stronger than it was before. Very good value for money too - and he'll repaint your frame if you want that also.
Bigyinn,
yep:
[img] 
[/img]
https://picasaweb.google.com/davepomphret/DropBox?authkey=Gv1sRgCMnL_dmNlcOBbA#5625504362171652914
🙁
is it not worth checking to see if someone is flogging a front end on retrobike/mountain cycle community area of mtbr?
Been looking for a whole new/old frame for a while...
Could do with a swingarm with disc tabs and a small seat subframe.
Bu,t they're like rocking-horse droppings and I'm skint! 😉
The skint bit never helps..
What you building up Dave?
Can't believe people would actually take a hacksaw to a frame. JUST LEAVE IT!
(I did file a slot in a solid cable stop once on a GT :oops:)