Forum menu
Topic starter
Anyone having problems with theirs? I went to regrease my BB recently and found that it was squirting the grease into the hollow rather than into the bearings. i re-seated the tool but it only did the same thing again.
Posted : 30/04/2010 4:22 pm
No problems here
Posted : 30/04/2010 5:32 pm
Is the little white plastic shim at the back of the bearing damaged?
As far as I can tell the grease tool uses this to deflect the grease back into the bearing.
Posted : 30/04/2010 5:36 pm
Topic starter
Not sure, but Ill have a look. But, it does it on both, which makes me think that it is me maybe doing something wrong
Posted : 01/05/2010 6:10 am
Same problem here.
One side worked, the other didn't, i'll check that seal.
Posted : 01/05/2010 7:17 am