Topic starter
I'm off to do some climbing soon, so will need to change my alpine from DH mode. How do you go about changing the mode on the rear mech please?
Posted : 04/04/2012 10:21 am
B,
Check it out here at Shimano Technical.
PaulD
Posted : 04/04/2012 10:42 am
There's a small aluminium piece that's attached to the mech by two small screws. You leave this on for close ratio (DH or Road) cassettes, or take it off if you're using a wide ratio cassette. As far as I can see, all it does is allow the mech to swivel back a few degrees more where it attaches to the derr hanger. I'm sure the tech doc referenced above gives you the same info, but I couldn't be bothered to read it!
Posted : 04/04/2012 10:49 am
Topic starter
Thanks guys. 🙂
Posted : 04/04/2012 11:04 am
