[Closed] chameleon ebb help

Don't take the bolts out - only loosen them, then use a 5mm allen key in the holes to rotate the shell.

cheers. I've already taken the bolts out. Problem is I can't get the big one back in. Any ideas?

HAHA! I did this. First see if the long bolt and cylinder shaped bolt will do up, if yes then slot the bolt back in its hole and push it down to the opening, you can use cotton buds to correct the position. Then it should tighten the first or second try.

If no then you have threaded the bolt like I did call Jungle and ask for a new one they sorted me for free.

In regards to the EBB lots of copperslip or grease then there are instructions [url= http://www.santacruzbikes.co.uk/tech/chameleon_tech.html ]here[/url]

Try here http://forums.mtbr.com/showthread.php?t=492389

tails, not wanting to sound like a total monger but do you just use the cotton buds to get the nut in place? Or can you take the thing apart?

I never took the bolts out when I was adjusting the EBB so I'm not sure what you can do. But it seems that since you've taken out the bolts the wedge should come appart and allow you to remove the whole unit. Then re-align the wedge nut with the bolt and put the two parts, eccentric bb and wedge, back together. Then grease and replace in the frame.

have a look here: [url= http://www.santacruzbicycles.com/tech/chameleon_tech.php ]EBB help[/url]

Hope this helps a little and you get it back together.

trailseeker - cheers for the linky. Its all starting to come clear!

cheers guy/baronspusulike. Shall post pics when done.

Just knock it out of the non drive side and reassemble it out of the bike. Give it a grease while your at it.

Good to hear it's coming together Rob. Looking forward to seeing you nail Set2Rise on it next year 😉