Forum menu
Hi folks got a box two groupset and it's bloody impossible to fit ba k wheel without removing rear derailleur, this is so naff.... Bike is a yeti asr 5.... anyone else had this problem?
Think this is something that should have been sorted before production!
Another issue I discovered was rear wheel removal. Because the mech doesn’t rotate far back enough on the hanger, you’re left with minimal room to release the cassette from the dropouts. There’s no way of turning the CamClutch off like you can with a Shimano derailleur, so the process is a whole lot harder than it needs to be. As such, I had to unbolt the derailleur to install or remove the rear wheel, which is terribly annoying. Again, this may be a non-issue for other frames.
Note to self.
Don't buy that mech. That is bloody mental. Like they didn't think of that or something?
Like the SR 12speed one on my ht ecen with Clutch off