Forum menu
Best way to package...
 

[Closed] Best way to package a bike frame?

Posts: 0
Free Member
Topic starter
 
[#6149923]

Hi Just wondering what is the best way to package a bike frame for as cheap as possible.


 
Posted : 28/04/2014 4:58 pm
Posts: 1199
Full Member
 

I've found Halfords are great for free boxes. Ask for a child's bike box if it's for a frame only. When I've asked for boxes before they have even had packing materials still inside!


 
Posted : 28/04/2014 5:00 pm
Posts: 0
Free Member
Topic starter
 

Great thank you!


 
Posted : 28/04/2014 5:20 pm
Posts: 61
Free Member
 

I've also take to just wrapping the frames up in cling film if nothing is around to protect them in.


 
Posted : 28/04/2014 5:22 pm
Posts: 5182
Free Member
 

I bubble wrap/bits of card wrap and then box, use plastic dropout spacers if you can blag any, if not then cut a piece of solid wood to fit and tape between the dropouts to protect the rear triangle from possible collapse due to overenthusiastic courieranderthals.


 
Posted : 28/04/2014 5:57 pm
Posts: 0
Free Member
 

Can't beat newspaper to stop the frame moving around and plenty of padding front and back


 
Posted : 28/04/2014 6:57 pm
Posts: 0
Free Member
 

Don't mean to hijack the thread but on a [i]somewhat[/i] similar note...
What's the best way to transport a complete bike on an airplane? I guess there are suitably-sized cardboard boxes but how much would you have to disassemble the bike? Can you get away with only removing the front wheel, handlebars? For the handlebars if you have hydro brakes can you keep the lines attached? I'm looking at transporting a complete hardtail but want the minimum of re-assembling at the other end. Thanks...


 
Posted : 28/04/2014 7:05 pm
Posts: 0
Free Member
 

Ive used grey foam pipe lagging for plumbing from b&q on main tubes of more expensive frames.
Free bike boxes from halfords too.


 
Posted : 28/04/2014 7:23 pm
Posts: 10654
Full Member
 

Cut holes centrally, in cardboard the same width as the box plus 6" each side.
Then push over the headtube, BB & seat tube junction, & fold as a "U" shape. Keeps the frame central in the box. If this makes any sense I'll be amazed. ๐Ÿ˜•


 
Posted : 28/04/2014 7:25 pm
Posts: 0
Free Member
 

Pipe lagging is what I use on frames usually. Protect the dropouts, head tube and top of the seat tube, they're the bits most likely to be damaged.


 
Posted : 28/04/2014 7:26 pm
Posts: 0
Free Member
Topic starter
 

Thanks for reply's guys.


 
Posted : 28/04/2014 11:01 pm
Posts: 5182
Free Member
 

Cut holes centrally, in cardboard the same width as the box plus 6" each side.
Then push over the headtube, BB & seat tube junction, & fold as a "U" shape. Keeps the frame central in the box. If this makes any sense I'll be amazed.

I enjoyed that massively, was like reading one of my own involuntary cryptogrammatical epics ๐Ÿ˜€


 
Posted : 28/04/2014 11:05 pm